Original Part
Alternative Part
1. LM2904ADMR2G Substitution Conclusion
Direct substitution carries risk and is not recommended for use at the original design parameter limits. While both are dual-channel general-purpose op-amps and are pin-compatible (noting the different package body widths), key parameters are degraded: Its maximum supply voltage (26V) is lower than the Original Part (30V), posing an overvoltage risk in applications operating near the original design's upper voltage limit. Its input offset voltage (2mV) and input bias current (45nA) are both inferior to the Original Part (1mV, 20nA), which may lead to greater error in circuits requiring higher DC accuracy. Furthermore, its slew rate is unspecified, whereas the Original Part is rated at 0.6V/µs, introducing a risk of underperformance in applications requiring moderate speed. Substitution should only be considered in applications where the supply voltage (e.g., ≤24V), accuracy, and speed requirements are all well within the original design's margin. Additionally, verification is required to ensure the narrower MSOP package (3.0mm wide) can physically replace the original TSSOP package (4.4mm wide) on the PCB.
2. LM2904VDMR2G Substitution Conclusion
Conditional substitution is possible, suitable for applications insensitive to power consumption and precision but requiring a wider supply voltage range. The key advantage of this variant is its extended supply voltage range (32V), which is superior to the Original Part (30V), offering greater voltage headroom. The trade-off is significant degradation in critical technical parameters: Its input offset voltage is as high as 7mV, an order of magnitude worse than the Original Part (1mV), making it highly unsuitable for applications requiring high DC accuracy (e.g., sensor signal amplification). Concurrently, its quiescent current (1.5mA/channel) is more than double that of the Original Part (0.7mA/channel), which will significantly increase system power consumption. It also uses the narrower MSOP package. This part can only substitute for low-frequency applications operating over a wide voltage range with extremely relaxed requirements for offset voltage and power dissipation, such as comparators or simple signal buffers.
Analysis ID: 6240-F18C000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com