Original Part
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-SSOP
Alternative Part
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-SSOP
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-TSSOP
1. SN74ABT16245ADLR Substitution Conclusion
From a drop-in replacement perspective, the SN74ABT16245ADLR is compatible in terms of package and basic logic function. However, a key technical downgrade exists, making the substitution "conditionally viable." The primary difference is that this TI device belongs to the standard ABT family, whereas the original Nexperia part (74ABTH) features an "H" suffix indicating integrated bus-hold functionality. After substitution, when the bus enters a high-impedance state, the TI device cannot maintain the previous logic state on its pins via internal circuitry as the original part does. This may lead to floating pins, indeterminate logic levels, increased system power consumption, or potential logic errors. On a positive note, its low-level output current (64 mA) is superior to the original part's (12 mA), offering stronger drive capability. Therefore, substitution is acceptable if the application circuit does not rely on bus-hold functionality (e.g., the bus is always actively driven or has reliable external pull-up/pull-down resistors) and the package (48-BSSOP) is an exact match. Otherwise, a reassessment of the bus stability design is required.
2. SN74ABT162245DGGR Substitution Conclusion
The SN74ABT162245DGGR is similar to the original part in logic function and key electrical parameters. However, its package differs, categorizing it as "pin-compatible but package-incompatible." Direct replacement is not feasible and would require a PCB layout redesign. The differences are as follows: First, its package is a 48-TSSOP (6.10 mm width), while the original part uses a 48-BSSOP (7.50 mm width). Although the pinout is identical, the differing body width and footprint prevent compatibility with existing PCB pads. Second, similar to the TI device mentioned above, it likely lacks the original part's bus-hold functionality, representing another critical functional omission. Its output current specifications list two sets of values, indicating its drive capability may vary dynamically under different conditions, but the range covers the original part's performance. Consequently, this device cannot serve as a direct replacement for the existing on-board component. It should only be considered as a new candidate device for evaluation (including bus-hold necessity) when undertaking a new design or if PCB modifications are acceptable.
Analysis ID: 56EB-1B2D000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com