Original Part
Alternative Part
Optoisolator Transistor with Base Output 5000Vrms 1 Channel 8-DIP
1. 6N136M-V Substitution Conclusion
The 6N136M-V is a viable direct substitute for the original part, as it matches all key parameters: isolation voltage, output type and current, and channel count. The primary differences are its larger package footprint (10.16mm vs. 7.62mm), which requires verification of PCB clearance, and its higher forward voltage, Vf (1.45V vs. 1.3V). This higher Vf necessitates a slightly higher input-side supply voltage to achieve the same drive current, which may impact the driver circuit design or result in marginally lower LED current. A notable advantage is that the 6N136M-V provides well-defined CTR and switching time specifications, facilitating performance evaluation and circuit verification post-substitution. Provided the physical dimensions are acceptable and sufficient margin exists in the driver circuit, it can be considered a reliable alternative.
2. PS8501L1-AX Substitution Conclusion
The PS8501L1-AX meets the critical isolation and channel configuration requirements. A potential advantage is its significantly higher output voltage capability (35V vs. 20V), offering greater margin in high-side load applications. However, its forward voltage, Vf (1.7V), is substantially higher, imposing more stringent demands on the input-side drive voltage. This mismatch may prevent proper operation or cause severe LED current deficiency in the original driver circuit. Additionally, its package is larger than the original part (10.16mm vs. 7.62mm). While its electrical withstand performance is superior, direct substitution carries significant risk and limited feasibility unless circuit modifications (e.g., increasing drive voltage or reducing the current-limiting resistor) are implemented and the physical fit is confirmed.
Analysis ID: F1D2-E652000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com