Original Part
Alternative Part
Optoisolator Transistor with Base Output 5300Vrms 1 Channel 8-DIP
Optoisolator Transistor with Base Output 5300Vrms 1 Channel 8-DIP
1. 6N136-X001 Substitution Conclusion
The 6N136-X001 can serve as a direct replacement in most applications; however, attention must be paid to output voltage margin. Its advantages include higher isolation voltage (5300Vrms > 5000Vrms) and maximum forward current (25mA > 12mA), providing greater safety and drive margin, along with a specified switching speed (200ns). The key difference is its lower maximum output voltage (Vout max) of 15V compared to the Original Part's 20V. If the operating voltage or potential voltage spikes across the optocoupler output (collector-emitter) in the original application circuit approach or exceed 15V, there is a risk of breakdown. A reassessment of the actual voltage stress in the circuit is therefore essential.
2. SFH6136-X001 Substitution Conclusion
The SFH6136-X001 is a closer substitute in terms of electrical withstand voltage and speed specifications, but input drive conditions must be recalculated. Its maximum output voltage (25V) is higher than that of the Original Part, offering better output safety margin, while its isolation voltage and switching speed are consistent with the 6N136-X001. The critical difference lies in its typical forward voltage (Vf typ) of 1.6V, which is significantly higher than the Original Part's 1.3V. Under the same input drive current, this results in a higher required drive voltage for its LED. If driven by the original circuit, the actual forward current (If) may be insufficient, potentially compromising the current transfer ratio (CTR) and signal transmission reliability. Adjusting the current-limiting resistor may be necessary to ensure adequate drive current.
Analysis ID: 1911-E69B000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com