Original Part
Alternative Part
1. BA3404F-E2 Substitution Conclusion
Direct substitution is not recommended due to low feasibility. The key difference lies in the output configuration: the original part features a differential output, whereas the BA3404F-E2 is a push-pull output. Their output stage circuit topologies and operating principles are fundamentally different, which may prevent proper operation when driving differential loads (such as certain ADCs or comparator applications). Additionally, its quiescent current (2 mA) is twice that of the original part (1 mA), leading to significantly higher power consumption. The output drive current (30 mA) is lower than the original (40 mA), resulting in slightly weaker load capability. Moreover, its package is a wide-body type (4.40 mm) and is incompatible with the original narrow-body package (3.90 mm), which directly impacts PCB layout.
2. LM358DRG3 Substitution Conclusion
Substitution is relatively feasible and can be considered as a direct alternative, though attention should be paid to potential performance degradation. The gain bandwidth product (700 kHz) is lower than that of the original part (1 MHz), which may impair signal processing capability at higher frequencies or under high closed-loop gain. Its input offset voltage (3 mV) is also slightly higher than the original (2 mV), which could affect applications with stringent DC accuracy requirements. However, core parameters such as supply voltage range (3–30 V), output current (40 mA), quiescent current (1 mA), and package type are well matched to the original part. Furthermore, its input bias current (20 nA) is superior. In most general-purpose amplification circuits operating at mid-to-low frequencies with moderate precision demands, the LM358DRG3 should function adequately.
Analysis ID: F7F8-B825000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com