Original Part
General Purpose Digital Isolator 2500Vrms 1 Channel 100Mbps 25kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
Alternative Part
General Purpose Digital Isolator 3750Vrms 1 Channel 15Mbps 35kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
General Purpose Digital Isolator 3750Vrms 1 Channel 15Mbps 35kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
1. SI8716BC-A-IS Substitution Conclusion
Direct substitution is not viable. While its isolation voltage rating (3750 Vrms) and common-mode transient immunity (35 kV/µs) surpass those of the original part, offering a reliability advantage, critical performance parameters are significantly degraded: the data rate is substantially reduced from 100 Mbps to 15 Mbps, accompanied by a notable increase in propagation delay and pulse width distortion. This device is only suitable for low-speed signal isolation applications. If directly substituted in medium- to high-speed communication circuits (e.g., higher baud-rate UART/SPI or pulse signal paths), it will likely cause signal waveform distortion, data errors, or system timing failures. Therefore, it may only be considered if the original application's channel speed is confirmed to be well below 15 Mbps and has very relaxed timing requirements.
2. SI8719BC-A-IS Substitution Conclusion
Direct substitution is not viable. Its technical parameters are largely identical to the SI8716BC-A-IS, sharing the same core limitations: the data rate (15 Mbps vs. 100 Mbps) and timing performance (propagation delay, pulse width distortion) are severely inadequate compared to the original part and cannot meet high-speed application demands. Furthermore, according to Skyworks' naming convention, the `SI8719` part typically indicates an output logic that is inverted relative to its input, whereas the original part (ISO721) and the SI8716 generally feature non-inverting outputs. Direct replacement would cause a system logic level inversion, potentially leading to downstream circuit functional errors. Thus, in addition to electrical parameter mismatch, there exists a fundamental incompatibility in logic function, necessitating a re-evaluation of the entire signal chain design.
Analysis ID: 4617-357C000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com