Original Part
General Purpose Digital Isolator 2500Vrms 1 Channel 100Mbps 25kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
Alternative Part
General Purpose Digital Isolator 2500Vrms 1 Channel 1Mbps 35kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
General Purpose Digital Isolator 3750Vrms 1 Channel 15Mbps 35kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
1. Substitution Conclusion for SI8610AB-B-ISR
Direct substitution with this part is fundamentally unfeasible. While it offers compatible isolation voltage (2500Vrms), package (8-SOIC), and a wider supply voltage range (2.5V-5.5V), along with superior common-mode transient immunity (35kV/µs), it suffers from a critical flaw. Its data rate is limited to 1Mbps, which is two orders of magnitude lower than the original 100Mbps specification. Furthermore, its propagation delay (35ns) and pulse width distortion (25ns) are significantly higher. This device is incapable of handling any mid-to-high frequency digital signals and is suitable only for extremely low-speed switching state isolation. Forcing a substitution in a 100Mbps application would result in severe signal distortion or complete communication failure, leading to a substantial degradation or total loss of system performance.
2. Substitution Conclusion for SI8720BC-A-IS
This part can serve as a substitute under specific conditions, but a rigorous evaluation of system requirements is mandatory. Its advantages include a higher isolation voltage (3750Vrms) and stronger common-mode transient immunity (35kV/µs), with compatible package and supply voltage range. However, the key limitation is its data rate of 15Mbps, which is substantially lower than the original 100Mbps, and it exhibits a longer propagation delay (50ns). It is unsuitable for any application requiring signal speeds above 15Mbps, such as high-speed communication interfaces (e.g., USB, high-speed UART) or fast digital control loops. Substitution is only viable if the actual signal frequency in the original application is significantly below 15Mbps and a higher isolation voltage is required. Otherwise, insufficient bandwidth will lead to signal integrity issues and timing errors.
Analysis ID: 9BFE-6008000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com