Original Part
Alternative Part
1. LM2904DR Substitution Conclusion
The LM2904DR can serve as a substitute in most general-purpose, non-critical DC to mid-low frequency applications. The key differences lie in its lower gain-bandwidth product (700 kHz vs. 1.1 MHz) and lower maximum supply voltage (26 V vs. 32 V) compared to the original part. In scenarios requiring higher frequency response (e.g., above several hundred kHz) or operation between 26 V and 32 V, the LM2904DR may not meet performance requirements. However, for common circuits such as sensor signal conditioning, voltage followers, and low-pass filters, its performance is adequate and compatible.
2. LM2904DT Substitution Conclusion
The LM2904DT can be considered as a substitution option, but requires careful evaluation due to its mixed performance trade-offs. Compared to the original part, it offers a slightly lower gain-bandwidth product (700 kHz) and a lower maximum supply voltage (30 V vs. 32 V), which limits its use in high-frequency or near-rail voltage applications. On the positive side, it features a higher slew rate (0.6 V/µs vs. 0.3 V/µs) for faster large-signal step response and a lower input offset voltage (2 mV vs. 3 mV), which benefits DC accuracy. It should be noted, however, that its typical quiescent current (700 µA) is higher than that of the original part (500 µA), making it less advantageous in ultra-low-power designs. A substitution decision should be made based on the specific priorities of the application.
Analysis ID: DBF5-ADD9000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com