Original Part
Alternative Part
1. AD746JRZ Substitution Conclusion
The substitution is essentially not viable. While the package is compatible and the supply voltage ranges overlap, there are fundamental differences in core performance. The AD746JRZ is a JFET-input op-amp featuring an extremely low input bias current (110 pA), making it suitable for applications like high-impedance sensor interfaces. However, this differs from the application positioning of the original standard bipolar op-amp. Its offset voltage (300 µV) is twice that of the original part, making it unsuitable for applications demanding high DC precision. Furthermore, its quiescent current (7mA) is significantly higher than the original device's, which would lead to a notable increase in power dissipation and heat generation. It could serve as a functional replacement only in specific scenarios where extremely low input bias current is the paramount requirement and other performance compromises are acceptable. It is not a direct equivalent drop-in replacement.
2. LT1355CS8TRPBF Substitution Conclusion
Substitution is feasible under specific conditions. This part offers a decisive advantage in slew rate (400V/µs), making it exceptionally well-suited for high-speed signal processing. However, its supply voltage range (5V to 30V) has a lower maximum than the original part; it is therefore unsuitable if the original system operates near 36V. Its input bias current (80 nA) is superior to the original, but its offset voltage (300 µV) is similarly worse. If the application circuit operates within 30V, requires extremely high signal response speed, and can tolerate some loss in DC precision along with a slightly higher cost, then the LT1355 represents a powerful performance upgrade. Otherwise, it is not applicable.
Analysis ID: 12BB-28D9000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com