Original Part
SRAM - Asynchronous Memory IC 4Mbit Parallel 55 ns 48-TFBGA (6x8)
Alternative Part
SRAM - Asynchronous Memory IC 4Mbit Parallel 10 ns 48-CABGA (9x9)
SRAM - Asynchronous Memory IC 4Mbit Parallel 10 ns 48-CABGA (9x9)
1. Substitution Conclusion for 71V416L10BE
The 71V416L10BE can functionally replace the IS62WV25616BLL-55BLI, as both are 4Mbit (256K x 16) asynchronous parallel SRAMs. However, critical differences must be evaluated before substitution. Regarding speed, the 71V416L10BE offers a significantly faster access time of 10 ns compared to the original part's 55 ns, providing superior timing performance. It is essential to verify whether the host controller can support this tighter timing or remains compatible. For voltage range, the original component supports 2.5V to 3.6V, whereas the 71V416L10BE is specified for 3V to 3.6V only. Direct substitution is not possible if the system operates below 3V. Both devices use a 48-ball BGA, but the original part is in a TFBGA package (6x8 mm), while the 71V416L10BE uses a CABGA package (9x9 mm). The different pad layout and footprint necessitate a PCB layout redesign. Substitution is feasible only if the system supply voltage is ≥3V, the host controller's timing is compatible, and the package change is acceptable.
2. Substitution Conclusion for 71V416L10BEG8
The 71V416L10BEG8 has identical core parameters to the 71V416L10BE (10 ns speed, 3V–3.6V voltage range, 48-CABGA package). The suffix "G8" likely indicates minor variations in packaging or temperature range (typically tape-and-reel or industrial grade). Therefore, its substitution feasibility is identical to that of the 71V416L10BE. The key differences remain the narrowed voltage range (no support for 2.5V) and the larger package size (CABGA area > TFBGA). The former may cause incompatibility in low-voltage systems, while the latter requires PCB rerouting. Although the speed increase to 10 ns is theoretically compatible, system timing margins must be verified. Substitution for the original part is recommended only when the supply voltage is ≥3V, the PCB design can be adapted for the new package, and timing requirements are met. Otherwise, it is not advised.
Analysis ID: BF48-8B01000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com