Original Part
Alternative Part
1. AD746JRZ Substitution Conclusion
This device can serve as a replacement in certain applications, but key differences must be considered. The AD746JRZ employs a J-FET input stage, with an input bias current (110 pA) significantly lower than the RC4580ID’s 100 nA, making it suitable for high-impedance sensor interfaces or precision signal conditioning. However, its supply voltage range (9 V to 36 V) is narrower than the original part’s 4 V to 32 V, particularly due to its higher minimum operating voltage, which may prevent direct compatibility in low-voltage systems. Additionally, its output drive capability (25 mA) is only half that of the original, which could impact performance under heavy loads. The slew rate (75 V/µs) is notably higher than the original’s 5 V/µs, benefiting high-frequency signal processing, but circuit stability must be carefully addressed.
2. LT1355CS8TRPBF Substitution Conclusion
This amplifier is a viable substitute in most scenarios, though drive requirements should be evaluated. The LT1355CS8TRPBF is a voltage-feedback op-amp with an extremely high slew rate (400 V/µs) and a quiescent current (1 mA per channel) lower than the original, making it well-suited for high-speed, low-power applications. However, its output current (30 mA) remains below the RC4580ID’s 50 mA, potentially limiting performance when driving low-impedance loads. The supply range (5 V to 30 V) overlaps well with the original, though its upper limit is slightly lower. Input bias current (80 nA) is in the same order of magnitude as the original, and DC precision (offset voltage 300 µV) is marginally better, making it suitable for general audio or signal amplification. If the system relies on the RC4580ID’s wider lower voltage margin (4 V) or higher output current, load compatibility should be re-verified.
Analysis ID: AFCB-452D000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com