Original Part
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-SSOP
Alternative Part
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-SSOP
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-TSSOP
1. 74ABTH162245ADL,11 Substitution Conclusion
From a functional and logical perspective, this part can serve as a substitute for the original part. Both are non-inverting, dual 8-bit, 3-state transceivers with identical voltage ranges and the exact same package (48-BSSOP), achieving physical pin-to-pin compatibility. The key difference lies in the low-level output drive capability (IOL): the original part is rated at 64mA, whereas the substitute part is rated at 12mA. The substitute part exhibits a significantly reduced sink current capability. If the original circuit design relies on high current drive (e.g., for driving multiple parallel loads or long cables), direct substitution may degrade signal integrity (manifested as slower rise times, increased voltage drops) or cause functional failure. However, if the original application involves only light loads or point-to-point level shifting, substitution is generally viable. Substitution can proceed only after confirming that the actual load current requirement is below 12mA.
2. 74ABTH162245ADGG,1 Substitution Conclusion
This part is functionally and electrically identical to the previous Nexperia part, including its output current ratings (32mA/12mA). Therefore, its core distinction from the original part is similarly the significantly lower low-level output drive capability (12mA vs. 64mA). Additionally, there is a package difference: it uses a narrower-body 48-TSSOP package instead of the original 48-BSSOP. The two are not physically pin-to-pin compatible, requiring adjustments to the PCB pad layout. Feasibility of substitution is constrained by two factors: first, the low drive current must be assessed against the application's requirements; second, a board redesign is necessary to accommodate the new package. Substitution should only be considered during a board revision cycle and only after confirming the load current demand is within the new part's capability.
Analysis ID: 0AD3-2DD6000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com