Original Part
70 Ohms @ 100 MHz 1 Power Line Ferrite Bead 0603 (1608 Metric) 3.5A 22mOhm
Alternative Part
60 Ohms @ 100 MHz 1 Power Line Ferrite Bead 0603 (1608 Metric) 4A 20mOhm
1. ACML-0603U-700-T Substitution Conclusion
Substitution is feasible and recommended as a preferred alternative. This part exhibits high consistency with the original part in key performance parameters: impedance (70Ω @ 100MHz), package (0603), and filter type (single‑line power line) are identical. Furthermore, it offers improvements in critical specifications: the rated current is increased from 3.5A to 4A, and the maximum DC resistance is reduced from 22mΩ to 20mΩ. Under the same application conditions, this allows the substitute to handle higher load currents with lower conduction loss and reduced temperature rise. The part length is slightly increased by 0.05mm (to 1.65mm), which is generally compatible with standard PCB pad layouts. Overall, its electrical performance fully matches and slightly exceeds the original, and mechanical installation is compatible, enabling a direct drop‑in replacement.
2. HFZ 1608PF-600T40 Substitution Conclusion
Substitution requires evaluation due to a key parameter deviation. The primary difference between this part and the original lies in the impedance value: its impedance at 100MHz is 60Ω, approximately 14% lower than the original 70Ω. This may result in slightly weaker noise suppression around the target frequency band (especially near 100MHz), potentially affecting the attenuation performance of the power‑line filter. Other parameters such as package, current rating (4A), and DCR (20mΩ) are similar to the ACML part and are either superior to or equal to the original specifications. If the original circuit design strictly requires 70Ω impedance or has limited margin, substitution could degrade filtering performance. If the design has sufficient margin or the actual noise frequency deviates from 100MHz, substitution may be acceptable. It is recommended to verify the filtering effectiveness in the specific circuit before replacement.
Analysis ID: 9A9F-C9D4000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com