Original Part
80 Ohms @ 100 MHz 1 Ferrite Bead 0603 (1608 Metric) 600mA 100mOhm
Alternative Part
80 Ohms @ 100 MHz 1 Signal Line Ferrite Bead 0603 (1608 Metric) 600mA 100mOhm
1. EMI0603R-68 Substitution Conclusion
When key parameters such as package size, rated current, and DC resistance are fully aligned, the primary difference of the EMI0603R-68 lies in its nominal impedance of 68Ω@100MHz, which is slightly lower than the original part’s 80Ω. Near the same target frequency of 100MHz, its attenuation of high‑frequency noise will be somewhat weaker. If the circuit has a strict impedance requirement at that specific frequency, direct substitution may lead to a slight degradation in filtering performance. In applications where the impedance tolerance for the filter is relaxed or sufficient design margin exists, this part can serve as a functional replacement. However, it is recommended to verify the actual high‑frequency noise suppression after substitution to ensure it meets the design requirements.
2. GZ1608U800CTF Substitution Conclusion
The GZ1608U800CTF matches the original part in all core parameters including impedance (80Ω@100MHz), current rating, DC resistance, package, and mechanical dimensions. Moreover, it is explicitly marked as a “Signal Line” type, which enhances its suitability for signal‑line filtering applications. From a parameter comparison perspective, this part is a feasible direct substitute; the only differences are the manufacturer and part number, while its electrical and physical characteristics are compatible with the original design. It is advisable during actual replacement to confirm that its high‑frequency impedance curve aligns with that of the original part across the relevant frequency band, and to perform necessary circuit performance verification to ensure seamless integration of the filtering characteristics.
Analysis ID: 3972-1120000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com