Original Part
Alternative Part
1. 24AA64T-I/ST Substitution Conclusion
The primary differences of the 24AA64T-I/ST lie in its clock frequency, which is limited to 400 kHz (compared to the original's 1 MHz), and its access time of 900 ns (versus the original 400 ns). Its I2C communication rate and data read speed are significantly lower than the original part. It can serve as a functionally compatible substitute only in low-speed applications where the bus clock requirement is not stringent (≤400 kHz) and read latency is not critical. If the original design operates at or near a 1 MHz clock, direct substitution may lead to communication failures or degraded performance.
2. AT24C64D-XHM-T Substitution Conclusion
The AT24C64D-XHM-T matches the original part in key specifications such as clock frequency (1 MHz) and voltage range. The main deviation is a slightly longer access time (550 ns vs. 400 ns). During sequential read operations by the host, the data hold time between consecutive bytes is marginally increased. However, this difference generally falls within the timing tolerance of most 1 MHz I2C bus implementations. This part represents a near-drop-in replacement with high feasibility. It is recommended to perform read/write timing verification on the actual circuit.
Analysis ID: E32C-238A000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com