Original Part
Alternative Part
1. TL082CMX/NOPB Substitution Conclusion
The TL082CMX/NOPB, while a dual JFET-input op-amp from the same series and package-compatible, exhibits significantly inferior key performance parameters, making direct substitution a high-risk undertaking. Critical deviations include: an input offset voltage as high as 5mV (far exceeding the TLE2082's 700µV), severely degrading DC accuracy and rendering it unsuitable for precision amplification; a notably lower slew rate of 13V/µs (vs. 40V/µs for the TLE2082) and gain-bandwidth product of 4MHz (vs. 10MHz), resulting in inadequate high-frequency signal response; a weaker output drive capability with only 17mA output current (vs. 48mA); and a more restricted supply range of ±18V (vs. the TLE2082's 4.5-38V single/dual supply), limiting design flexibility. This substitute is only appropriate for non-critical circuits with relaxed requirements for precision, speed, and power supply.
2. LT1355CS8TR Substitution Conclusion
The LT1355CS8TR offers package compatibility and superior bandwidth and slew rate (12MHz, 400V/µs) compared to the original part. However, its fundamentally different input architecture necessitates careful evaluation before substitution. The core difference lies in its voltage-feedback topology (vs. JFET), resulting in an input bias current of 80nA—nearly 4000 times higher than the TLE2082's 20pA. This will introduce significant error in high-impedance sensor or integrator circuits. Its supply range of 5-30V is also slightly narrower, with a higher minimum voltage requirement than the TLE2082's 4.5-38V range. Substitution may be considered if the application does not rely on the JFET's ultra-low input current characteristics and requires higher speed, but input impedance matching, noise performance, and DC accuracy must be thoroughly re-validated.
Analysis ID: 465F-C1C6000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com