Original Part
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-SSOP
Alternative Part
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-TSSOP
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-SSOP
1. 74FCT162245CTPACT Substitution Conclusion
Substitution is feasible, but package compatibility must be verified. This part matches the original device in all key electrical parameters—logic type, voltage range, and output current (24mA). The primary difference lies in the package: it uses a 48-TFSOP (6.10mm width) versus the original 48-BSSOP (7.50mm width). Although the pinout is identical, the approximately 18.7% reduction in body width may affect mechanical compatibility with the existing PCB pad layout. It is necessary to confirm whether the current pad design can accommodate the narrower package. Additionally, the manufacturer change from Renesas to Texas Instruments requires attention to supply chain stability and lot-to-lot consistency.
2. 74FCT16245TPVCG4 Substitution Conclusion
Substitution should be approached with caution, and drive capability matching must be evaluated. This device uses the exact same package as the original (48-BSSOP), offering high physical compatibility. However, a key difference is its significantly higher output current capability (32mA high / 64mA low, compared to the original 24mA/24mA). The increased drive strength may lead to faster edge rates and improved noise margins, but it could also introduce signal integrity risks such as overshoot and crosstalk—particularly in high-load or long-trace scenarios, where signal quality should be re-verified. Furthermore, the absence of "22" in the part number may indicate minor internal architecture adjustments. It is recommended to measure critical timing parameters (e.g., propagation delay) to ensure full functional compatibility.
Analysis ID: C05B-47FE000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com