Original Part
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-TSSOP
Alternative Part
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-SSOP
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-SSOP
1. 74FCT162245ATPVCT Substitution Conclusion
This device can serve as a direct replacement, provided that package compatibility is verified. The key difference lies in the package dimensions: the original part is supplied in a 48-TFSOP package (6.10mm width), whereas the substitute is offered in a 48-BSSOP package (7.50mm width). The two packages differ in PCB footprint and outline. If the existing PCB layout was designed for a 6.10mm-wide package, direct pad-to-pad mounting will not be possible. The PCB layout must therefore be modified to accommodate the wider package, or sufficient installation clearance must be confirmed. Electrically, the two devices are fully matched in both parameters and functionality.
2. 74FCT16245TPVCG4 Substitution Conclusion
This component is functionally compatible, but the impact of its enhanced drive capability on the existing system must be evaluated. The most notable technical difference is the output drive current: the original device is rated at 24mA / 24mA, while the substitute offers 32mA / 64mA. The replacement part provides greater fan-out and capacitive load driving capability, but may also introduce higher switching noise, faster edge rates, and slightly increased power consumption. When substituting, the original design must be reviewed for signal integrity (overshoot, ringing), power integrity (noise and decoupling), and transient current during bus contention to ensure system stability. The package also differs from the original (both are 48-BSSOP, 7.50mm wide), presenting the same physical compatibility concerns.
Analysis ID: 9DB1-EA02000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com