Original Part
Alternative Part
1. ADA4084-2ARMZ-R7 Substitution Conclusion
In applications where high output current and high slew rate are not critical, the ADA4084-2ARMZ-R7 can serve as a replacement for the original LM7322MME/NOPB. However, key performance differences must be considered: the ADA4084-2ARMZ-R7 offers only 30mA output current (versus 100mA for the LM7322), a slew rate of 4.6 V/µs (versus 18 V/µs), a gain-bandwidth product of 15.9 MHz (versus 20 MHz), and a slightly narrower supply range (3–30V compared to 2.5–32V). Its capability to drive capacitive or low-impedance loads is weaker, and its large-signal high-frequency response is slower, while its minimum operating voltage is somewhat higher. On the other hand, it exhibits significantly better input bias current (140 nA vs. 1.1 µA) and input offset voltage (60 µV vs. 700 µV) than the original part, making it more suitable for high-precision signal conditioning. Additionally, its quiescent current is lower (625 µA per channel vs. 2.5 mA), which benefits low-power designs.
2. ADA4084-2ARMZ-RL Substitution Conclusion
The substitution conclusion for the ADA4084-2ARMZ-RL is identical to that for the ADA4084-2ARMZ-R7, as both share the same electrical specifications (potential differences lie only in packaging form, such as reel vs. tape-and-reel). Feasibility of substitution likewise depends on the application requirements: if the system does not require high output drive capability or high slew rate, but prioritizes input precision, low power consumption, and low noise, this part can replace the original. However, if the original design relies on the LM7322’s 100 mA output current or 18 V/µs slew rate to handle fast large signals, substitution may lead to performance degradation or even failure. Careful verification of load conditions and dynamic response requirements is necessary.
Analysis ID: 2599-83E3000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com