Original Part
Alternative Part
1. TPS2021DG4 Substitution Conclusion
The TPS2021DG4 is not a direct replacement for the AP2161SG-13. The key differences are as follows: First, the output types differ. The AP2161SG-13 is a P-channel switch, whereas the TPS2021DG4 is an N-channel switch. This implies the drive logic levels are likely inverted, necessitating a re-evaluation or modification of the control circuitry. Second, the output current capability differs. The TPS2021DG4 has a maximum output current of 600mA, which is lower than the original part's 1A. Direct substitution in applications where the original design load current exceeds 600mA would pose an overload risk. Third, the fault protection features differ. The TPS2021DG4 lacks reverse current protection. In applications with a risk of reverse voltage (such as hot-swap or battery backup scenarios), this omission could lead to safety hazards or device damage. Substitution should only be considered in applications where the load current is definitively below 600mA, reverse current protection is not required, and modifying the drive logic is acceptable.
2. TPS2021DR Substitution Conclusion
The TPS2021DR is functionally and electrically identical to the TPS2021DG4 in all key parameters. The difference typically lies only in the suffix (which often denotes packaging or environmental compliance variations, e.g., "DR" commonly indicates tape and reel packaging). Therefore, its substitution conclusion is identical to that for the TPS2021DG4: it is not a direct replacement for the AP2161SG-13. The primary technical disparities—output type (P-channel vs. N-channel), current capability (1A vs. 600mA), and protection features (presence or absence of reverse current protection)—along with their implications and the conditions for potential substitution remain consistent with the conclusion stated above. It may only be considered for use in specific scenarios characterized by low load current, no reverse current risk, and the ability to adapt the drive logic.
Analysis ID: 8373-6456000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com