Original Part
Alternative Part
1. LM2904DGKR Substitution Conclusion
Direct substitution is not recommended. The LM2904DGKR exhibits critical technical deviations from the original ADA4062-2ARMZ-RL. Key differences include an input bias current four orders of magnitude higher (20 nA vs. 2 pA), a significantly larger input offset voltage (3 mV vs. 750 µV), lower gain bandwidth product (700 kHz vs. 1.4 MHz) and slew rate (0.3V/µs vs. 3.3V/µs), and a narrower maximum supply voltage range (26 V vs. 36 V). In applications involving high-impedance signal sources, high DC precision, moderate-frequency signals, or wide supply voltages—such as sensor signal conditioning or precision integrator circuits—the LM2904DGKR would introduce substantially higher input errors, reduced bandwidth and response speed, and potential supply compatibility issues. Its performance is not a suitable match.
2. LM2904ADMR2G Substitution Conclusion
Direct substitution is not recommended. The primary discrepancies between the LM2904ADMR2G and the ADA4062-2ARMZ-RL similarly center on input characteristics and dynamic performance. It features an extremely high input bias current (45 nA), an input offset voltage (2 mV) substantially greater than the original, a slightly lower gain bandwidth product (1 MHz), and an unspecified slew rate (typically below 1V/µs for this family). Its supply voltage range (3 V to 26 V) also fails to cover the original's 36V upper limit. These differences indicate that in JFET amplifier applications requiring very low input current, high precision, and wide supply operation—such as photodetection or high-impedance measurement—this part would lead to severe signal distortion, DC offset errors, and potential supply design conflicts, rendering it unsuitable as a replacement.
Analysis ID: 0032-96F4000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com