Original Part
Zero Delay Buffer IC 133MHz 1 8-SOIC (0.154", 3.90mm Width)
Alternative Part
1. CDCVF2505DG4 Substitution Conclusion
There is a notable risk in using this part as a direct substitute, although core functionality is largely compatible. The key difference lies in the output logic levels: the original part (2305B-1DCGI8) supports a wider range of CMOS, LVCMOS, and TTL outputs, whereas the CDCVF2505DG4 only supports LVTTL outputs (VOH ≈ 2.4V, VOL ≈ 0.4V). If the original design relies on higher CMOS levels (e.g., close to VCC) or TTL loads with different threshold voltages, direct replacement may cause logic level mismatch, reduced noise margin, or even drive failure. However, in systems where all loads are standard LVTTL interfaces, this substitution is viable. All other critical parameters—PLL bypass, 1:5 fanout, 3.3V supply, SOIC-8 package—as well as the core zero-delay/clock driver function are fully matched. Additionally, the TI part offers a higher maximum frequency of 200MHz, providing greater speed margin.
2. CDCVF2505DRG4 Substitution Conclusion
The feasibility of substituting with this part is identical to that of the CDCVF2505DG4, and the same conclusion applies. The suffix “R” typically indicates only a reel packaging variation; there is no difference in electrical parameters or silicon die between the “DRG4” and “DG4” versions. Similarly, this part carries the risk of narrowed output logic level support (LVTTL only). Provided the load interfaces are compatible, it retains the same PLL functionality, voltage, package, and fanout capability as the original part, making it a pin-compatible alternative while offering higher frequency performance margin. The primary—and only—determining factor for the engineer remains the logic level compatibility of the downstream circuitry.
Analysis ID: 35A7-4144000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com