Original Part
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-SSOP
Alternative Part
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-SSOP
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-SSOP
1. CY74FCT162245ATPVC Substitution Conclusion
From the perspective of core logic function, supply voltage, and package, the CY74FCT162245ATPVC can be considered a potential substitute for the original part. The primary technical difference lies in the output drive capability: the original Renesas device offers asymmetric drive currents of 32mA (high-level) and 64mA (low-level), whereas this TI variant provides a symmetric 24mA drive. This implies that when driving heavy capacitive loads or low-impedance lines, the TI part has weaker sink (pull-down) capability, which may affect signal rise/fall times or noise margin. If the original design fully utilized the robust drive strength of the original part—especially the 64mA low-level current—direct substitution could pose risks under high-load conditions. Conversely, under lighter loads, substitution should be acceptable. Additionally, it is necessary to verify whether timing parameters, such as propagation delay, fall within the system tolerance.
2. CY74FCT162245TPVC Substitution Conclusion
The substitutability of the CY74FCT162245TPVC is highly consistent with the ATPVC variant described above, as both share identical electrical parameters. The key difference from the original part similarly lies in the output drive current (symmetric 24mA versus the original asymmetric 32mA/64mA). This means that, in terms of electrical performance, the TPVC faces the same limitations as the ATPVC: after substitution, fan-out capability or signal integrity may be marginally degraded, particularly in applications requiring strong pull-down current. Typically, the "A" designation in the part number may relate to secondary features, such as improved power consumption or lot specifications, but based on the provided parameters, both parts behave identically externally. As long as the application does not rely on the additional drive margin of the original part and timing requirements are met, this device can serve as a substitute. It is recommended to validate key waveforms under actual load conditions prior to replacement.
Analysis ID: 6649-B7B1000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com