Original Part
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-SSOP
Alternative Part
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-TSSOP
Transceiver, Non-Inverting 2 Element 8 Bit per Element 3-State Output 48-SSOP
1. 74FCT162245ATPACT Substitution Conclusion
The 74FCT162245ATPACT can serve as a substitute option requiring design modifications. The key differences are: the package differs (original part is a 7.50mm-wide 48-SSOP, while this part is a 6.10mm-wide 48-TSSOP), necessitating a complete rework of the PCB layout and pad design, as direct drop-in soldering is not possible. Additionally, the drive strength differs (original part features 32mA/64mA asymmetric drive, whereas this part provides 24mA/24mA symmetric drive). Notably, the sink current (output low) capability is significantly reduced. This may introduce signal integrity risks, such as increased rise/fall times and reduced noise margin, when driving heavy loads or multiple parallel bus lines. A thorough assessment of the actual load conditions is required.
2. 74FCT162245ATPVCT Substitution Conclusion
The 74FCT162245ATPVCT is a highly viable, nearly drop-in replacement alternative. The differences are minimal: the package is identical (both are 7.50mm-wide 48-SSOP), ensuring full physical dimension and pinout compatibility for direct soldering onto the existing PCB. The sole electrical difference lies in the drive strength (original part: 32mA/64mA asymmetric drive; this part: 24mA/24mA symmetric drive). The output current capability, particularly the sink current, is lower than the original part. For most standard bus driver applications, the 24mA symmetric drive is sufficient. However, if the original design leveraged the stronger sink capability of the original part (e.g., for driving remote or highly capacitive loads), it is critical to validate system timing and signal quality under worst-case conditions after substitution.
Analysis ID: DA57-483C000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com