Original Part
Alternative Part
1. ISL28113FEZ-T7A Substitution Conclusion
In most general-purpose applications, the ISL28113FEZ-T7A can serve as an upgraded substitute for the TSV621AICT, though its suitability depends on the system's sensitivity to power consumption and drive capability. Key differences include: significantly higher bandwidth (2 MHz vs. 420 kHz) and slew rate (1 V/µs vs. 0.14 V/µs), making it better suited for higher-frequency or fast-transient-response applications. However, its quiescent current increases to 90 µA (approximately 3 times that of the original part), which may increase power consumption in battery-operated devices. The output current is reduced to 22 mA (from 74 mA), limiting its ability to drive heavy loads. Input offset voltage improves to 500 µV, offering superior DC accuracy. The minimum supply voltage rises to 1.8 V (from 1.5 V), making it incompatible if the system operates between 1.5 V and 1.8 V. In summary, this part can provide a performance-upgraded alternative if the system does not require very low supply voltage or high output current drive and can tolerate a moderate increase in power consumption.
2. ISL28114FEZ-T7 Substitution Conclusion
The ISL28114FEZ-T7 is only suitable for applications with stringent bandwidth and slew rate requirements that can tolerate a substantial increase in power consumption; its overall feasibility as a direct replacement is low. Critical differences include: bandwidth (5 MHz) and slew rate (2.5 V/µs) are much higher than those of the original part, making it appropriate for high-speed signal processing. However, its quiescent current reaches 300 µA (approximately 10 times that of the original part), which may be unacceptable for power-sensitive designs. The output current of 31 mA remains lower than the original part's 74 mA, limiting drive capability. Input offset voltage is the same as the ISL28113 (500 µV), providing good accuracy. The minimum supply voltage is also 1.8 V, restricting its use in low-voltage applications. Unless the system explicitly requires higher bandwidth and can accommodate the associated power penalty, this part is not recommended as a direct substitute for the TSV621AICT.
Analysis ID: 6A5C-B907000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com