Original Part
Alternative Part
1. LM124DG4 Substitution Conclusion
From a core parameter perspective, the LM124DG4 is similar to the original part LM2902YDT in basic specifications such as supply voltage range, bandwidth, and input bias current. However, key differences exist: First, its output type is differential (vs. push‑pull in the original), making it unsuitable for directly driving ground‑referenced single‑ended loads and likely requiring additional circuit adaptation. Second, its output current is only 30mA (vs. 60mA original), halving the drive capability, which may affect performance with capacitive or low‑impedance loads. Third, it lacks AEC‑Q100 automotive qualification and would not meet requirements for automotive or high‑reliability applications. Substitution may be considered only in non‑automotive, low‑load industrial applications where the output structure can be accommodated; otherwise, direct replacement is not recommended.
2. LM2902KVQDRG4 Substitution Conclusion
The LM2902KVQDRG4 belongs to the same TI LM2902 family as the original part, with highly consistent basic parameters (supply, bandwidth, slew rate, etc.). Two notable differences are present: First, its output current is also 30mA (only half of the original), which limits output drive capability and may degrade performance when driving high‑current loads. Second, the output type is not explicitly stated (the LM2902 series typically uses push‑pull outputs, but the datasheet should be verified); if it matches the original, structural compatibility is maintained, though the drive‑current gap still needs evaluation. Finally, no AEC‑Q100 qualification is mentioned, suggesting it is likely an industrial‑grade device. For non‑automotive applications with low load‑current demands (≤30mA), it can be considered a functional substitute, but output response and load compatibility must be verified. If higher drive or automotive qualification is required, direct substitution is not acceptable.
Analysis ID: 1A09-5180000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com