Original Part
Alternative Part
1. SA18SS-06 Substitution Conclusion
The SA18SS-06 can serve as a direct replacement for the original FMAT7467-6, as both share identical attenuation (6 dB), power rating (2 W), and impedance (50 Ω), and employ the same SMA inline module package with good mechanical compatibility. The primary distinction is that the SA18SS-06 offers an extended frequency range of DC to 18 GHz, compared to the original part’s 12 GHz. This provides improved bandwidth performance and signal integrity in high‑frequency applications such as Ku‑band and above, making it suitable for systems requiring wider frequency coverage or future upgrades. However, note that its specified “SSMA” connector may have slight mechanical differences from standard SMA interfaces; it is recommended to verify interface compatibility prior to actual assembly.
2. FMAT1012 Substitution Conclusion
The FMAT1012 matches the original FMAT7467-6 in key parameters including attenuation, power rating, and impedance. However, its frequency range is limited to DC–6 GHz, which is significantly lower than the original part’s 12 GHz. This device is only suitable for mid‑to‑low frequency applications (e.g., below L‑band). If used in high‑frequency signal paths of the original design (such as C‑ or X‑band), it may degrade attenuation characteristics or introduce additional insertion loss. Therefore, the FMAT1012 should be considered only as a downgrade substitute in systems where the operating frequency does not exceed 6 GHz. Otherwise, it will fail to meet bandwidth requirements and may compromise system performance.
Analysis ID: 0FBE-54D0000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com