Original Part
Alternative Part
1. SA6S5W-03 Substitution Conclusion
The substitution of the SA6S5W-03 for the original FMAT7460-3 part is conditionally viable. The primary technical discrepancy lies in the frequency range (SA6S5W-03: 0-6 GHz vs. original: 0-12.4 GHz). If the maximum operating frequency of your application system is below 6 GHz, the SA6S5W-03 can serve as a fully equivalent drop-in replacement in terms of attenuation value, power handling, and impedance matching. However, for any system involving signals within the 6 GHz to 12.4 GHz band, the SA6S5W-03 is unsuitable. Its attenuation accuracy and overall performance cannot be guaranteed in this upper band, and forced usage may lead to signal distortion or component failure.
2. SA3S5W-03 Substitution Conclusion
The substitution of the SA3S5W-03 for the original FMAT7460-3 part is highly constrained and generally not recommended. The most critical specification mismatch is again the frequency range (SA3S5W-03: 0-3 GHz, significantly lower than the original's 12.4 GHz). The SA3S5W-03 can only operate safely and effectively within its specified sub-3 GHz band. For any application exceeding 3 GHz—particularly in typical microwave bands such as C or X Ku-bands covered by the original part—using this substitute will result in severe performance degradation. This includes significant deviation from nominal attenuation values, degraded VSWR, and potential thermal damage due to high-frequency resonances. Therefore, substitution should not be considered unless operation is strictly and reliably confined to frequencies below 3 GHz.
Analysis ID: E490-8550000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com