Original Part
Alternative Part
1. SA6-06 Substitution Conclusion
The SA6-06 matches the original FMAT7466-6 in key parameters such as attenuation, power handling, and impedance. However, its maximum operating frequency (6 GHz) is only half that of the original part (12 GHz). If your application circuit operates below 6 GHz, the SA6-06 can serve as a direct electrical performance substitute. For signal frequencies exceeding 6 GHz, using the SA6-06 will result in deviation from the nominal attenuation value, increased insertion loss, and potential impedance mismatch. This can lead to signal reflection and distortion. Therefore, it is only suitable for low-frequency scenarios and is not a viable substitute for high-frequency applications.
2. FMAT1011 Substitution Conclusion
The FMAT1011 exhibits technical parameters highly similar to the SA6-06 and shares the same critical limitation: a significantly reduced operating frequency range (0-6 GHz) compared to the original part (0-12 GHz). Furthermore, the omission of "SS" in its description suggests potential subtle differences in connector surface finish (e.g., plating) versus the original. This could have a potential impact on long-term mating cycle durability and stability in highly corrosive environments. The substitution feasibility conclusion for the FMAT1011 is identical to that for the SA6-06: it is only suitable for applications where the operating frequency is definitively below 6 GHz. It cannot replace the original part in high-frequency applications. Additionally, attention must be paid to whether its connector's mechanical and environmental endurance meets the specific application requirements.
Analysis ID: 01F5-309F000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com