Original Part
Alternative Part
1. BA2904SF-E2 Substitution Conclusion
Feasible, but with performance degradation risks. The BA2904SF-E2 is compatible with the original LM358DRG3 in basic architecture (dual general-purpose op-amp, supply voltage range) and package. However, key dynamic parameters are notably weaker: its slew rate (0.2 V/µs) and gain-bandwidth product (500 kHz) are lower than those of the original (0.3 V/µs, 700 kHz), limiting response speed and bandwidth when processing high-speed or higher-frequency signals. Additionally, its output current capability (30 mA) is lower than the original’s (40 mA), resulting in slightly weaker drive capability for capacitive or low-impedance loads. Substitution is acceptable if the application does not require high-frequency response or fast transient performance and operates under light loads; otherwise, bench verification is recommended.
2. LM358S-13 Substitution Conclusion
Requires careful evaluation due to significant differences. While the LM358S-13 matches the original in gain-bandwidth product (700 kHz) and offers better input offset voltage (2 mV), its output is specified as “differential” (a designation not noted in other variants), suggesting a potential difference in output stage architecture. Moreover, its input bias current (45 nA) is substantially higher than the original (20 nA), which may introduce greater error with high-impedance signal sources. The quiescent current (1 mA) is double that of the original (500 µA), directly impacting power consumption and thermal design. Substitution carries higher risk if the application is sensitive to input current accuracy or power dissipation, or if the output structure is incompatible. For general low-frequency, non-precision circuits, replacement may be considered, but circuit-level verification is strongly advised beforehand.
Analysis ID: 6013-1FB6000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com