Original Part
Voltage Feedback Amplifier 2 Circuit Rail-to-Rail 8-MSOP
Alternative Part
1. TLV2402CDGKR Substitution Conclusion
Direct substitution with the TLV2402CDGKR is largely impractical. Its extremely low slew rate (0.0025 V/µs) and gain-bandwidth product (5.5 kHz) result in severely limited signal processing speed and insufficient bandwidth, making it unsuitable for applications requiring mid-frequency (MHz range) operation or fast transient response as intended with the original part. Additionally, its output current capability is only 200 µA, which provides minimal drive strength. While its supply current is very low—characteristic of an ultra-low-power design—this fundamentally differs from the original general-purpose, moderate-speed amplifier's performance profile.
2. BD7562FVM-TR Substitution Conclusion
Substitution with the BD7562FVM-TR may be feasible under constrained conditions, provided system requirements are rigorously evaluated. Its slew rate (1 V/µs) and gain-bandwidth product (1 MHz) are relatively low, leading to noticeably reduced high-frequency performance and signal response speed, and it is not suitable for the mid-band applications typical of the original part. The output current of 14 mA is also modest and may limit capacitive load drive capability. However, its lower input bias current (1 pA) offers an advantage in high-impedance sensor interface circuits. If the application is limited to low-frequency, small-signal processing and the supply voltage range (5–14.5 V) is acceptable, substitution could be considered.
Analysis ID: C0F2-BFD2000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com