Original Part
Alternative Part
1. LMV821M7X Substitution Conclusion
Direct substitution is generally not feasible and should only be considered in applications where DC precision is extremely relaxed and greater speed and output drive capability are prioritized. Key deviations include: input bias current (100 nA) is over 30,000 times higher than the original part (3 pA), input offset voltage (3.5 mV) is 7× worse than the original (500 µV), and minimum operating voltage is 2.5 V versus 1.8 V for the original. The LMV821M7X exhibits significantly degraded DC accuracy and low-input-current performance, making it unsuitable for high-impedance sensor signal conditioning, precision integrators, or 1.8 V low-voltage systems. However, its gain-bandwidth product (5.6 MHz vs. 2 MHz) and slew rate (2 V/µs vs. 1 V/µs) are higher, and output current capability (45 mA vs. 22 mA) is greater. It may be better suited for general-purpose signal buffering where bandwidth, speed, or load drive are critical and larger DC errors can be tolerated.
2. LMV931MG Substitution Conclusion
This device can serve as a direct replacement in most scenarios, particularly where stronger output drive is needed and a slight compromise in precision is acceptable. Differences are as follows: input bias current (14 nA), though three orders of magnitude higher than the original (3 pA), remains in the low range; input offset voltage (1 mV) is double that of the original (500 µV); slew rate (0.42 V/µs) is slightly lower than the original (1 V/µs). However, output current (100 mA) is substantially increased—about 4.5 times that of the original. While DC precision is marginally reduced, which may affect ultra-high-accuracy measurements, the enhanced output drive enables direct driving of heavier loads such as small motors or LED arrays. The operating voltage range (1.8 V–5.5 V) remains fully compatible with the original. With its balanced performance profile, the LMV931MG represents a closer alternative.
Analysis ID: FA65-5744000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com