Original Part
Alternative Part
1. LMV931MFX Substitution Conclusion
From a key parameter perspective, direct substitution of the LMV931MFX for the ISL28113FHZ-T7 is conditionally viable, with the core difference being their respective performance focus. The primary disadvantages of the LMV931MFX are its approximately 4600x higher input bias current (14nA vs. 3pA) and 2x higher offset voltage (1mV vs. 500µV). These characteristics may introduce unacceptable error in applications involving high-impedance source signals or requiring high DC precision, such as photodiode amplification or precision sensor conditioning. Its dynamic performance (slew rate 0.42V/µs, GBW 1.5MHz) is also inferior, limiting signal processing speed and bandwidth. Conversely, its output drive capability (100mA) is significantly stronger than the original part (22mA), making it more suitable for directly driving low-impedance loads. Substitution can be considered if the application is insensitive to input error and speed but requires stronger output drive, and if the supply range (1.8V-5.5V) and package (SOT-23-5) are compatible. Otherwise, it is not recommended.
2. LMV931MF Substitution Conclusion
The substitution conclusion for the LMV931MF regarding the ISL28113FHZ-T7 is identical to that for the LMV931MFX; it is conditionally feasible. This is because the suffix difference (MF vs. MFX) typically denotes variations only in packaging or reel specifications, while their core electrical parameters (input bias current 14nA, offset voltage 1mV, slew rate 0.42V/µs, gain-bandwidth product 1.5MHz, supply current 116µA, output current 100mA) are exactly the same. Consequently, the technical differences and their impact compared to the original ISL28113FHZ-T7 are also identical: notably higher input error and lower speed, but with stronger output drive. Under the same application prerequisites (where input precision and speed are not critical, but strong output drive is needed, and package/supply compatibility exists), the LMV931MF can serve as a substitute. Otherwise, replacement should be avoided. In practical implementation, it is necessary to verify whether the MF and MFX suffixes meet specific PCB footprint and procurement requirements.
Analysis ID: 42D1-C858000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com