Original Part
Alternative Part
1. LM258DRG4 Substitution Conclusion
Direct substitution is not recommended. Significant differences exist between the two devices in key performance parameters, making a direct replacement highly likely to cause severe system performance degradation or even failure. The primary distinctions are as follows: The ISL28210 is a J-FET input amplifier whose input bias current (0.3 pA) is approximately seven orders of magnitude lower than that of the LM258 (20 nA). The LM258 would introduce substantial input current error in applications such as high-impedance sensor interfaces. Furthermore, the ISL28210's gain bandwidth product (12.5 MHz vs. 700 kHz) and slew rate (20 V/µs vs. 0.3 V/µs) are significantly higher than those of the LM258. If the original circuit is intended for high-speed signal processing, substitution would result in insufficient bandwidth and signal distortion. Additionally, the ISL28210 offers 10 times greater precision in input offset voltage (300 µV vs. 3 mV), which directly impacts output accuracy in precision amplification circuits. The LM258DRG4 is suitable only for non-critical, low-cost general-purpose amplification applications where input impedance, speed, and precision are not stringent requirements. It cannot serve as a direct replacement for a high-performance J-FET amplifier.
2. LM258DRG3 Substitution Conclusion
Direct substitution is not recommended, and the conclusion is identical to that for the LM258DRG4. Based on the provided parameters, the LM258DRG3 and LM258DRG4 share identical core electrical specifications (such as amplifier type, bandwidth, slew rate, bias current, offset voltage, etc.). Any differences between them typically relate only to non-performance aspects like environmental certifications or lot identification codes. When confronted with the high-performance requirements of the original ISL28210, the LM258DRG3 similarly suffers from the fundamental performance gaps of excessively high input bias current, insufficient bandwidth and slew rate, and inadequate precision. It is not viable for applications demanding high input impedance, high speed, or high accuracy and therefore cannot be considered a feasible direct substitute.
Analysis ID: 61DE-E653000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com