Original Part
Alternative Part
1. AD621BRZ-RL Substitution Conclusion
Given that the AD621BRZ-RL matches the LT1167ACS8-1 in basic parameters such as package, supply voltage range, quiescent current, and slew rate, it can serve as a functional substitute. However, the impact of its reduced accuracy must be carefully evaluated. The key differences are: the input bias current increases to 500pA (10× that of the original part), introducing greater error when measuring high-impedance signal sources; the input offset voltage rises to 50µV (approximately 3.3× that of the original part), directly degrading the absolute accuracy of DC measurements; and the bandwidth specification shifts from a gain-bandwidth product of 1MHz to a -3dB bandwidth of 800kHz—though of the same order, the specifications are expressed differently. If the application demands extremely high microvolt-level signal accuracy and low bias current (e.g., a precision sensor front-end), substitution is not feasible. If the system has sufficient margin or relaxed requirements for these accuracy parameters, direct replacement can be implemented.
2. AD621ARZ-RL Substitution Conclusion
The AD621ARZ-RL shares essentially the same characteristics as the AD621BRZ-RL, but its input offset voltage further increases to 75µV (5× that of the original part), making it the least accurate of the three. The conclusion regarding its substitution feasibility is the same as for the AD621BRZ-RL, but the conditions are more stringent: it is only suitable for applications least sensitive to input offset voltage accuracy. Beyond the previously mentioned differences in bias current and bandwidth, this additional offset voltage imposes greater initial error and precision loss due to temperature drift on the system. It is nearly unsuitable for any application where the high precision of the LT1167 is a core design consideration, and can only serve as a cost-sensitive alternative under extremely relaxed accuracy requirements.
Analysis ID: A9BA-1A5F000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com