Original Part
Alternative Part
1. Substitution Conclusion for BA2904SF-E2
The BA2904SF-E2 is not a direct substitute and requires careful evaluation based on the application. Key differences lie in significantly degraded dynamic performance: both gain-bandwidth product (500 kHz vs. 700 kHz) and slew rate (0.2 V/µs vs. 0.3 V/µs) are lower than the original part. This will limit performance in circuits handling higher frequency signals or requiring fast transient response, potentially leading to insufficient bandwidth or waveform distortion. Furthermore, its output drive capability is slightly weaker (30 mA vs. 40 mA), and its different package width (4.40mm vs. 3.90mm) necessitates a PCB layout redesign. Substitution should only be considered for applications with non-critical bandwidth and speed requirements, and where PCB modifications are acceptable.
2. Substitution Conclusion for LM358S-13
The LM358S-13 is not a direct substitute and poses risks due to critical parameter mismatches. The most prominent discrepancy is its output type, specified as "Differential." This may be fundamentally different from the standard output characteristics of the LM358D and could prevent proper operation in classic LM358 circuits designed for single-supply use with output swinging near ground. Additionally, its static power consumption is doubled (quiescent current 1mA vs. 500µA), which is detrimental for low-power designs. The higher input bias current (45 nA vs. 20 nA) will introduce greater error in applications with high-impedance signal sources. Although bandwidth is identical and the supply voltage range is wider, these core differences make it unsuitable for circuits relying on the standard characteristics of the original part.
Analysis ID: 40A4-1F3B000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com