Original Part
Alternative Part
1. LM258DRG4 Substitution Conclusion
The LM258DRG4, a general-purpose dual op-amp, is a low-feasibility substitute for the LT1057IS8 due to significant differences in key performance parameters. Its input bias current (20 nA vs. 7 pA) is three orders of magnitude higher, input offset voltage (3 mV vs. 220 µV) is degraded by over ten times, and both bandwidth (700 kHz vs. 5 MHz) and slew rate (0.3 V/µs vs. 13 V/µs) are substantially lower than the original part. The LM258DRG4 cannot meet the requirements of high-precision, high-speed signal processing applications such as precision sensor amplification or high-speed filtering. It is suitable only for cost-sensitive, performance-lenient DC or low-frequency applications like voltage comparison or power supply control.
2. ADA4000-2ARZ-R7 Substitution Conclusion
The ADA4000-2ARZ-R7, a JFET-input dual op-amp, presents a high-feasibility substitute for the LT1057IS8, as its core performance is well-matched and certain parameters are superior. Input bias current (5 pA) and offset voltage (200 µV) are comparable to the original part, bandwidth (5 MHz) is identical, and slew rate (20 V/µs) is even higher. Although its supply range (8–36 V) requires attention to the minimum voltage limit, it remains compatible with most application scenarios. The ADA4000-2ARZ-R7 can seamlessly assume the role of the original part in high-precision, high-speed analog circuits such as instrumentation amplifiers and active filters. However, verification of output current capability (28 mA vs. unspecified) and suitability under extremely low supply voltage conditions is recommended.
Analysis ID: 0200-FBDB000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com