Original Part
Alternative Part
1. LMV324BG-13 Substitution Conclusion
The LMV324BG-13 can serve as a limited substitute for the LMV604MA/NOPB, with performance differences that may impact high-precision and low-power applications. The input bias current of the LMV324BG-13 is as high as 15 nA (significantly greater than the original part’s 0.02 pA), which can introduce noticeable leakage current in circuits requiring high input impedance, such as sensor signal amplification, potentially degrading measurement accuracy. Its input offset voltage is 1.7 mV (compared to 550 µV for the original), introducing larger error when amplifying DC signals. The supply current per channel is 340 µA (versus 100 µA for the original), indicating higher power consumption and making it unsuitable for battery-powered devices. Its output current of 90 mA (lower than the original’s 113 mA) also limits its ability to drive heavy loads. However, its slew rate, gain bandwidth product, and supply voltage range match those of the original device. Therefore, substitution remains feasible in general amplification applications where precision and power consumption are not critical.
2. LMX324IDT Substitution Conclusion
The LMX324IDT can be considered as a potential substitute for the LMV604MA/NOPB, but key performance differences must be noted. The LMX324IDT has an input bias current of 27 nA (much higher than the original’s 0.02 pA), resulting in greater input leakage that may affect stability in high-impedance circuits. Its input offset voltage is as high as 4 mV (compared to 550 µV for the original), leading to reduced amplification accuracy, especially in precision amplifier circuits. The output current is 70 mA (lower than the original’s 113 mA), limiting drive capability and making it unsuitable for high-load applications. Slew rate is reduced to 0.7 V/µs (from 1 V/µs), which may constrain high-speed signal processing. On the other hand, its gain bandwidth product is slightly higher (1.3 MHz vs. 1 MHz), offering wider bandwidth, and its minimum supply voltage is lower (2.3 V vs. 2.7 V), providing enhanced flexibility in low-voltage operation. Overall, substitution may be considered in applications where precision and drive strength are less critical, but wider bandwidth or lower voltage operation is required.
Analysis ID: 6D80-5682000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com