(HKG) +86 755 8277 4696
WhatsAppWhatsApp
English
SkyChip
0
Original Part

RF Attenuators 3dB 0 Hz ~ 18 GHz 50 Ohms 2W SMA In-Line Module

Quote
Alternative Part

RF Attenuators 3dB 0 Hz ~ 6 GHz 50 Ohms 2W SMA In-Line Module

Quote

RF Attenuators 3dB 0 Hz ~ 3 GHz 50 Ohms 2W SMA In-Line Module

Quote
1. LCAT1000-03 Substitution Conclusion The feasibility of substituting with the LCAT1000-03 is strictly contingent upon the maximum operating frequency of the specific application. This part offers a perfect match to the original AT-103V in terms of attenuation value (3dB), power handling capacity (2W), and connector interface (SMA). However, its specified operational frequency range (0-6 GHz) is significantly narrower than the original's 0-18 GHz. In application scenarios involving high-frequency signals above 6 GHz—such as certain Ku-band satellite communications or high-end test and measurement equipment—the LCAT1000-03 cannot guarantee key performance parameters including attenuation accuracy, impedance matching, and power handling. This could lead to signal distortion or component failure, rendering it an unsuitable substitute. Conversely, if the system operates definitively below 6 GHz, the LCAT1000-03 presents a viable, lower-cost alternative from both electrical and mechanical perspectives.
2. LCAT1001-03 Substitution Conclusion The substitution feasibility for the LCAT1001-03 is low and is restricted to low-frequency applications only. While this part matches the original in attenuation value, power rating, and interface type, its frequency range (0-3 GHz) is merely one-sixth that of the original AT-103V (0-18 GHz). This substantial gap limits its suitability exclusively to UHF and lower frequency band scenarios, such as general radio communications or certain base station equipment. For any applications in the mid-to-high frequency bands and above (e.g., C, X, or Ku bands), its performance will degrade severely and fail to meet system requirements entirely. Unless it can be confirmed with absolute certainty that the application bandwidth will never exceed 3 GHz, it is not recommended as a substitute for the AT-103V.
Analysis ID: 1659-067A000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com