Original Part
Alternative Part
1. LTC1481CS8TRPBF Substitution Conclusion
The LTC1481CS8TRPBF is only viable as a substitute under specific conditions, with its most critical limitation being a significant reduction in data rate (from 30 Mbps down to 2.5 Mbps). If the original system operates at or near the higher rate of 30 Mbps, substituting with this part will not guarantee proper communication timing or reliability, potentially leading to data errors or communication failure. However, if the original system already operates at a lower data rate (e.g., below 2 Mbps) and is not sensitive to the slight reduction in receiver hysteresis (from 50 mV to 45 mV, which marginally weakens noise immunity), then the LTC1481CS8TRPBF can serve as a speed‑downgrade alternative, given its full compatibility in interface protocol, operating voltage, and package. It is essential to verify the actual operating baud rate of the system before substitution.
2. LTC1483CS8TRPBF Substitution Conclusion
The LTC1483CS8TRPBF has very low feasibility as a substitute and should only be considered in extremely low‑speed applications. There is an order‑of‑magnitude difference in data rate (from 30 Mbps down to 250 kbps), which makes it completely unsuitable for any medium‑ to high‑speed communication scenarios. Similar to the LTC1481, its receiver hysteresis is also slightly lower than the original part. Unless the original design actually operates at a very low communication rate (well below 250 kbps) and there are specific cost or supplier constraints, this model is not recommended as a direct replacement. Choosing it entails a substantial sacrifice in communication bandwidth capability.
Analysis ID: 33B1-2FE5000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com