Original Part
Alternative Part
80 Ohms @ 100 MHz 1 Signal Line Ferrite Bead 0603 (1608 Metric) 600mA 100mOhm
1. EMI0603R-60 Substitution Conclusion
The EMI0603R-60 can serve as a viable substitute for the original EMI0603R-68. The primary difference lies in the impedance value, which is reduced from 68Ω to 60Ω (measured at 100MHz), representing a decrease of approximately 12%. This may result in slightly weaker attenuation of certain high‑frequency noise. However, for most general‑purpose filtering applications, the deviation remains within acceptable tolerance. All other key parameters—package size (0603), rated current (600mA), DC resistance (≤100mΩ), and mechanical specifications—are identical. Moreover, both parts belong to the same manufacturer’s product family, ensuring high process consistency. If the circuit does not demand stringent impedance accuracy (e.g., non‑critical resonant or filtering circuits), this part can be used as a drop‑in replacement. Nevertheless, it is recommended to verify noise suppression performance across the actual operating frequency range.
2. GZ1608U800CTF Substitution Conclusion
The GZ1608U800CTF offers potential feasibility as a substitute for the EMI0603R-68, but two technical differences should be noted. First, its impedance is increased to 80Ω (about 18% higher than the original part), which may provide stronger noise suppression at 100MHz. However, if the original circuit relies on specific impedance matching, this change could affect signal integrity or filtering characteristics. Second, the manufacturer differs (Sunlord replacing Delevan). Although package size, current rating, and DCR parameters are fully matched, and the part is explicitly designated as a signal‑line filter type, variations in core material and frequency‑response curves between manufacturers may exist. It is important to verify whether the impedance characteristics remain consistent across the actual application frequency band (e.g., higher or lower frequencies). Prior to substitution, it is advisable to review the impedance curve over the system’s operating frequency range and assess temperature stability. In high‑precision or high‑frequency circuits, empirical validation through measurement is strongly recommended.
Analysis ID: C97D-0DE7000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com