Original Part
Alternative Part
1. AD8682ARZ Substitution Conclusion
The AD8682ARZ, as a J-FET input operational amplifier, exhibits significant differences in key parameters compared to the original AS358AMTR-E1. It features substantially lower input bias current (6 pA vs. 20 nA), lower input offset voltage (350 µV vs. 2 mV), higher bandwidth (3.5 MHz), and higher slew rate (9 V/µs), along with lower quiescent current. These characteristics make it far superior to the original part in high-impedance signal acquisition, precision measurement, and high-frequency small-signal processing. However, its minimum supply voltage requirement is higher (9 V vs. 3 V), and its output drive capability is weaker (12 mA vs. 40 mA). Therefore, substitution is feasible only in precision or high-speed applications where the supply voltage is sufficient and high output current is not required. Designers must carefully consider the supply voltage range and load driving limitations.
2. LM358ADRG4 Substitution Conclusion
The LM358ADRG4 and the original AS358AMTR-E1 are both standard dual operational amplifiers with closely matched parameters. Key specifications such as input bias current (15 nA vs. 20 nA), input offset voltage (2 mV, identical), output current (40 mA, identical), and minimum supply voltage (3 V, identical) align well. Additionally, the LM358ADRG4 offers slightly lower quiescent current (500 µA vs. 700 µA), which helps reduce power consumption. The main differences lie in bandwidth (700 kHz vs. unspecified) and slew rate (0.3 V/µs), which may be lower than the unstated dynamic performance of the original device. For general DC or low-frequency applications, such as sensor amplification or voltage following, the LM358ADRG4 can serve as a direct replacement. However, if the original circuit relies on high-frequency operation or fast transient response, the dynamic parameters must be verified to ensure they meet system requirements.
Analysis ID: 2054-27AC000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com