Original Part
General Purpose Digital Isolator 2500Vrms 1 Channel 150Mbps 35kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
Alternative Part
General Purpose Digital Isolator 4000Vpk 1 Channel 100Mbps 15kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
General Purpose Digital Isolator 3000Vrms 1 Channel 25Mbps 25kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
1. ISO722QDRQ1 Substitution Conclusion
Direct substitution is not recommended. Although its isolation voltage (4000Vpk ≈ 2830Vrms) is higher than the original part, and its propagation delay and rise/fall times are comparable, two key parameters present significant disadvantages. First, its common-mode transient immunity (CMTI) is only 15kV/µs, which is substantially lower than the original part's 35kV/µs. In applications with high-voltage noise interference (e.g., motor drives, power supplies), this significantly increases the risk of false triggering and reduces system reliability. Second, its data rate (100Mbps) is lower than the original part's (150Mbps), creating a bottleneck in applications requiring high-speed signal transmission. This substitute is only suitable for low-to-medium speed scenarios with no stringent CMTI requirements and data rates below 100Mbps.
2. ISO7310CQDRQ1 Substitution Conclusion
This part is largely unsuitable as a replacement, with a considerable performance gap. The differences lie in its data rate (25Mbps) and propagation delay (58ns), which are far inferior to the original part's specifications (150Mbps, 13ns). It is completely unsuitable for any medium-to-high frequency signals or digital communications with strict timing requirements (e.g., high-speed SPI, digital I/O). Its use is limited to isolating very low-speed switching signals only. Although its CMTI (25kV/µs) is better than the ISO722's, it remains lower than the original part's. Its isolation voltage (3000Vrms) is in the same order of magnitude as the original part's (2500Vrms). Unless the application involves only extremely low-speed, delay-insensitive switch control, this part cannot fulfill the required function.
Analysis ID: 9E23-B238000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com