Original Part
General Purpose Digital Isolator 3750Vrms 1 Channel 15Mbps 35kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
Alternative Part
General Purpose Digital Isolator 4000Vpk 1 Channel 100Mbps 15kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
General Purpose Digital Isolator 3000Vrms 1 Channel 25Mbps 25kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
1. ISO722QDRQ1 Substitution Conclusion
Direct substitution is not recommended. While its data rate (100 Mbps) and propagation delay are significantly better than the original part, key isolation parameters are severely degraded. First, its isolation voltage is rated at 4000 Vpk (peak), approximately 2830 Vrms, which is lower than the original's 3750 Vrms. This indicates a weaker tolerance to continuous line-frequency high voltage. Second, its Common-Mode Transient Immunity (CMTI) is only 15 kV/µs, significantly lower than the original's 35 kV/µs. In environments with severe ground potential fluctuations caused by power switching (e.g., motor drives, power supplies), the risk of data transmission errors with this device increases substantially. Consideration may only be given in applications with extreme speed requirements, very low common-mode noise, and lower isolation voltage needs, provided a thorough re-evaluation of the system's safety margin is conducted.
2. ISO7310CQDRQ1 Substitution Conclusion
Substitution is conditionally recommended, subject to system margin evaluation. The core differences between this part and the original are the reduced isolation voltage (3000 Vrms vs. 3750 Vrms) and CMTI (25 kV/µs vs. 35 kV/µs), indicating diminished capability in high-voltage isolation strength and ultimate resistance to high-speed noise interference. However, its data rate (25 Mbps) is higher than the original, and it carries automotive-grade (AEC-Q100) certification, meeting a higher reliability standard. If the actual operating isolation voltage and common-mode noise levels in the target application are well below the original specifications, with sufficient design derating, and if higher data rates or automotive-grade reliability are required, then the ISO7310CQDRQ1 presents a viable upgrade/substitution option. A review of the isolation and noise requirements based on actual application conditions is mandatory.
Analysis ID: D844-D4EC000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com