Original Part
Alternative Part
Shunt Voltage Reference IC Adjustable 2.5V 36 VV ±0.4% 100 mA TO-92-3
1. LT1431CZTRPBF Substitution Conclusion
This part serves as a high-performance direct substitute. The key differences are its superior initial accuracy (±0.4% vs. ±1%) and improved temperature coefficient (30ppm/°C vs. 50ppm/°C). These characteristics enable it to provide a more stable and precise reference voltage over a wide temperature range, thereby enhancing overall system accuracy and temperature drift performance. However, it is critical to note that its reference pin minimum operating current (Iref) is 1mA, significantly higher than the Original Part's 40µA. When designing the divider resistor network, sufficient current must be guaranteed to flow into the reference pin for proper operation. In ultra-low-power or high-impedance divider applications, this may lead to startup failure or degraded accuracy. Recalculation and verification of the biasing circuit are therefore essential.
2. KA431LZTA Substitution Conclusion
This part is a cost-effective alternative from the same manufacturer and is generally viable. The primary differences are its nominal reference voltage of 2.495V (typical) instead of the standard 2.5V, and an initial accuracy of ±0.5%. In applications requiring an absolute reference voltage of 2.500V (e.g., high-precision ADC references), this minor voltage offset could introduce a systematic error. It is necessary to evaluate whether this small deviation falls within the system's error budget. Similarly, its reference pin minimum operating current (Iref) is also 1mA instead of 40µA, presenting the same biasing circuit design consideration as with the Original Part. The circuit must be checked to ensure it can supply adequate current to the reference pin; otherwise, normal operation may be compromised.
Analysis ID: 288A-8717000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com