Original Part
General Purpose Digital Isolator 3750Vrms 1 Channel 15Mbps 35kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
Alternative Part
General Purpose Digital Isolator 2500Vrms 1 Channel 150Mbps 25kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
General Purpose Digital Isolator 4000Vpk 1 Channel 150Mbps 25kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
1. ISO722MDRG4 Substitution Conclusion
Direct substitution of the ISO722MDRG4 for the SI8716BC-A-ISR requires careful evaluation. Key differences include lower isolation voltage (2500 Vrms vs. 3750 Vrms) and lower common-mode transient immunity (CMTI) (25 kV/µs vs. 35 kV/µs). However, the ISO722MDRG4 offers a higher data rate (150 Mbps vs. 15 Mbps) and superior signal transmission performance, characterized by a maximum propagation delay of 16 ns (vs. 50 ns) and a maximum pulse width distortion of 1 ns (vs. 25 ns). In applications where high-voltage isolation and robust noise immunity are not critical—such as low-voltage industrial control or communication interfaces—the ISO722MDRG4 can serve as a direct replacement, leveraging its higher speed and lower distortion. Conversely, in high-voltage isolation or high-noise environments (e.g., motor drives or medical equipment), its reduced isolation rating and CMTI may introduce reliability risks, necessitating a re-verification of the system's safety margin.
2. ISO721MMDREPG4 Substitution Conclusion
The substitution of the ISO721MMDREPG4 for the SI8716BC-A-ISR presents certain limitations. Notable differences include an isolation voltage specified as a peak value (4000 Vpk, approximately equivalent to 2830 Vrms, which is lower than the original 3750 Vrms) and a lower CMTI (25 kV/µs vs. 35 kV/µs). On the other hand, the ISO721MMDREPG4 provides a higher data rate (150 Mbps vs. 15 Mbps) and significantly improved dynamic performance, with superior specifications for propagation delay, distortion, and edge timing. For high-speed data links or applications demanding stringent signal integrity—such as digital isolated communication or sensor interfaces—the ISO721MMDREPG4 can deliver faster response and lower signal degradation. However, its lower isolation withstand voltage and CMTI may render it unsuitable for high-voltage or high-noise environments (e.g., power supply isolation or industrial automation main systems). Additionally, its supply voltage ranges (3 V to 3.6 V and 4.5 V to 5.5 V) exhibit a gap, requiring verification of power supply compatibility. Therefore, prior to substitution, the isolation and noise immunity requirements must be reviewed against the actual operating conditions.
Analysis ID: 7763-3587000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com