Original Part
80 Ohms @ 100 MHz 1 Signal Line Ferrite Bead 0603 (1608 Metric) 500mA 150mOhm
Alternative Part
80 Ohms @ 100 MHz 1 Power, Signal Line Ferrite Bead 0603 (1608 Metric) 300mA 300mOhm
1. MG1608-800Y Substitution Conclusion
From a review of key technical parameters, the MG1608-800Y matches the original part in impedance-frequency characteristics (80Ω@100MHz) and package size (0603). However, its rated current (300mA) is significantly lower than the original’s 500mA, and its DC resistance (300mΩ) is double that of the original (150mΩ). If used in circuits operating near the original design current (e.g., >300mA), this device may overheat or saturate due to overloading, leading to degraded filtering performance. The higher DC resistance will also increase line voltage drop and power dissipation, potentially affecting signal integrity or power efficiency. It is only suitable for filtering on signal lines with low current demand (≤300mA) and where DC loss is not critical. Direct substitution requires careful evaluation of actual operating current and loss tolerance.
2. MH1608-800Y Substitution Conclusion
The MH1608-800Y matches the original part in impedance-frequency characteristics and package size. Moreover, its rated current (3A) is considerably higher than the original’s 500mA, and its DC resistance (40mΩ) is significantly lower. This implies lower heating and higher reliability under the same load current, along with minimal DC loss and negligible impact on line voltage drop. However, note that its specified “Power, Signal Line” characteristic may be optimized for power line applications; its high-frequency impedance curve could differ slightly from the original (designed purely for signal lines). Verification of filtering response across the actual frequency band is recommended. Overall, this part is electrically feasible for direct substitution, particularly in applications with higher current demands or sensitivity to DC loss, but high-frequency performance should be validated in the actual circuit.
Analysis ID: 5485-D478000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com