Original Part
General Purpose Digital Isolator 3000Vrms 1 Channel 25Mbps 25kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
Alternative Part
General Purpose Digital Isolator 2500Vrms 1 Channel 1Mbps 35kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
General Purpose Digital Isolator 3750Vrms 1 Channel 15Mbps 35kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
1. SI8610AB-B-IS Substitution Conclusion
The SI8610AB-B-IS is a less viable substitute for the ISO7310FCD due to significant deviations in key parameters. Its isolation voltage is reduced to 2500Vrms (compared to the original 3000Vrms), which may fail to meet safety requirements in applications demanding high-voltage isolation. The data rate is substantially lower at 1Mbps (vs. 25Mbps), limiting its suitability for high-speed signal transmission. Although the common-mode transient immunity (CMTI) is improved to 35kV/µs (from 25kV/µs), enhancing noise immunity, and the propagation delay is faster (35ns vs. 58ns), the pulse width distortion is significantly higher at 25ns (compared to 4ns). This indicates potential degradation in signal timing accuracy, which could lead to bit errors or timing faults. Additionally, while the extended supply voltage range of 2.5V to 5.5V (vs. 3V to 5.5V) offers greater design flexibility, overall, the SI8610AB-B-IS is not a suitable direct replacement unless the application has relaxed requirements for isolation voltage and data rate while prioritizing higher CMTI.
2. SI8716BC-A-IS Substitution Conclusion
The SI8716BC-A-IS presents a partially feasible alternative to the ISO7310FCD, but careful evaluation of application requirements is necessary. Its isolation voltage is increased to 3750Vrms (from 3000Vrms), enhancing electrical safety. The CMTI is also improved to 35kV/µs (from 25kV/µs), which is beneficial for rejecting common-mode noise. However, the data rate is reduced to 15Mbps (vs. 25Mbps) and may not meet high-speed communication demands. While the slightly faster propagation delay (50ns vs. 58ns) is advantageous, the pulse width distortion is notably high at 25ns (compared to 4ns), indicating poorer signal edge consistency that could impact system timing and reliability. The extended supply voltage range of 2.5V to 5.5V (from 3V to 5.5V) provides a wider operating window. In summary, the SI8716BC-A-IS can be considered as a substitute if the application can tolerate a moderate data rate and higher pulse width distortion while prioritizing high isolation and CMTI. Otherwise, it may not be suitable for high-speed or high-precision timing applications.
Analysis ID: 6A7C-8F5D000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com