Original Part
General Purpose Digital Isolator 3000Vrms 1 Channel 100Mbps 85kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
Alternative Part
General Purpose Digital Isolator 3750Vrms 1 Channel 15Mbps 35kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
General Purpose Digital Isolator 3750Vrms 1 Channel 15Mbps 35kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
1. SI8718BC-A-IS Substitution Conclusion
Direct substitution is not feasible. This device can only be considered for degraded use in low-speed, low-noise applications. The primary performance gaps are as follows: the data rate is reduced from 100 Mbps to 15 Mbps, making it unsuitable for high-speed digital communication (e.g., high-speed modes of UART or SPI); the common-mode transient immunity (CMTI) is reduced from 85 kV/µs to 35 kV/µs, significantly degrading its noise immunity and reliability in harsh environments with high dV/dt noise from power switching (e.g., motor drives, power supplies); propagation delay and pulse width distortion are substantially increased, degrading signal timing accuracy, which may impact system synchronization or control loop performance. Substitution should only be considered when the application signal frequency is very low (well below 15 Mbps) and the electrical environment is clean.
2. SI8720BC-A-IS Substitution Conclusion
The conclusion is identical to that for the SI8718BC-A-IS: direct substitution is not viable, and it is only suitable for low-speed, low-noise scenarios. This is because the provided SI8720BC-A-IS shares identical key parameters (isolation voltage, data rate, CMTI, timing parameters, etc.) with the SI8718BC-A-IS. The two are effectively the same specification chip, with potential differences only in orderable part numbers or minor internal non-electrical variations. Consequently, their core performance gaps relative to the original target part (e.g., ISO7710D) – namely lower speed (15 Mbps vs. 100 Mbps), lower noise immunity (35 kV/µs vs. 85 kV/µs), and higher timing delays – are exactly the same, leading to identical application limitations.
Analysis ID: FDF2-29CE000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com