Original Part
Alternative Part
1. AD817ARZ-REEL7 Substitution Conclusion
The AD817ARZ-REEL7 is a viable substitute with a high degree of feasibility, though one key performance difference warrants attention. The differences are as follows: the slew rate is reduced from the original 400 V/µs to 350 V/µs, while the gain-bandwidth product (GBW) is increased from 45 MHz to 50 MHz, the maximum supply voltage is extended from 30 V to 36 V, and the output current capability is explicitly specified at up to 50 mA. The reduction in slew rate will slightly decrease the amplifier's response speed to large signals (such as high-amplitude steps or high-frequency square waves), potentially affecting its performance in very high-speed switching circuits or those processing full-scale, high-frequency signals. Conversely, the higher bandwidth and wider supply range are beneficial improvements, and the clarified output current capability enhances its ability to drive capacitive or resistive loads. For general-purpose high-speed amplification, video processing, and other applications not demanding the utmost in slew rate, the AD817 is a suitable alternative.
2. AD847JRZ-REEL7 Substitution Conclusion
The substitution feasibility of the AD847JRZ-REEL7 is fundamentally limited; direct replacement is not recommended. The core issue is incompatibility in supply voltage range. The differences include: a further reduction in slew rate to 300 V/µs, an improved, lower quiescent current of 5.3 mA, but most critically, its minimum operating voltage has increased from the original 5 V to 9 V. This device cannot operate in single-supply systems below 9 V or dual-supply systems of ±5 V and below, directly limiting its applicability. While its lower power consumption is an advantage, the decreased slew rate will also affect large-signal processing speed. It should only be considered as a substitute primarily aimed at reducing power consumption when the original circuit's operating voltage fully meets the 9 V to 36 V range and when slew rate requirements are not stringent. Otherwise, it is incompatible.
Analysis ID: 7603-8D2B000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com